.png)
M6027
TAT SPECIFICATION Page 1/2
TYPE | MIC | PREPARED | TAT ELECTRONICS CO., LTD. | ||
MODEL | EM-6027MP | CHECKED | |||
PVB DATE | SEP. -11– 2010 | APPROVED | CES No . | 06 | |
1. This specification is applied to electret condenser microphone unit Model EM-6027MP
(Built-in capacitor for RF-noise)
2. Measuring conditions : Temperature 20℃+2℃,humidity60%～80%.
3. Appearance and dimension: as per Fig.1
4. Electrical Specification :
4- 1) Directional Characteristic: Omni-Directional
4- 2) Sensitivity Range --37~43 dB at 1KHZ (0 dB=1 V/Pa) RL=2.2 KΩ VCC=2.0 V
4- 3) Impedance 2.2 KΩ+30% at 1KHZ (RL=2.2 KΩ)
4- 4) Frequency Response As Fig.3
4- 5) S/N ratio More than 58 dB
4- 6) Max Input Sound Level 110 dB S. P. L
4- 7) Operating Voltage 2.0V (1.1～10V)
4- 8) Circuit Current 500μA max (VCC=3.0V)
4- 9) Terminal Locations As per Fig.1
4-10) Electrical Circuit As per Fig.2
4-11) Capacitor 13pF
4-12) Storage Temperature -40 ~ 85 °C
4-13) Operating Temperature -40 ~ 85 °C
5. Reliability Tests:
After any following tests ,the sensitivity of the microphone unit shall not change more than +3 dB from initial value, and shall keep their initial operation and appearance. | ||
5.1 | High Temperature test | The microphone unit must be subjected to +85℃ for 200 Hours, and expose to room temperature for 6 Hours. |
5.2 | Low Temperature test | The microphone unit must be subjected to -40℃ for 200 Hours, and expose to room temperature for 6 Hours. |
5.3 |
Temperature Cycle test | The microphone unit must be subjected to following conditions (+50℃ 1H～room temp 1H～-10℃ 1H～room temp 1H) at 5 cycle, and expose to room temp for 6 Hours. |
5.4 |
Humidity Test | The microphone unit must be subjected to +40℃, 90% RH for 200 Hours, and expose to room temperature for 6 Hours. |
5.5 |
Drop Test | The microphone unit without package must be subjected to each 3 drops at three axes from the height of 1 meter to 20mm thick hardwood board. |
5.6 |
Vibration Test | The microphone unit must be subjected to each 3minutes vibration at three axes 3mm dynamic range, 1000 cycle/minute. |
5.7 | Soldering Heat Shock | To solder with a 30w soldering iron in a Aluminum soldering tooling at 260℃～300℃ for less than 2seconds. |
TAT SPECIFICATION Page 2/2
TYPE | MIC | PREPARED | WEI FANG ACT ELECTRONICS CO., LTD. | ||
MODEL | EM-6027MP-44~48DB | CHECKED | |||
PVB DATE | SEP.– 11- 2010 | APPROVED | CES No : | 0 6 | |
Fig.1: Appearance and dimension (Unit: mm Scale : 4 : 1)
.png "1(15).png")
Fig 2: Electrical circuit
.png "2(14).png")
Fig . 3: Frequency response
.png "3(13).png")
